Thank you balala - I was suspecting it's a small mistake that comes from just too little knowledge of the rainmeter. That small change did the job, now it is running as intended, thank you so much. I'm looking forward to help with the 2nd questions, even some general guidance regarding which elements from documentation to look into and the basic idea behind implementing such solution would be of big help!The only place where you can use the Update option is the [Rainmeter] section, where Update sets the interval of update of the skin (expressed in milliseconds). On meters and measure you don't use Update, but UpdateDivider. So replace the Update=-1 option of the [MeasureRandom] measure by UpdateDivider=-1.
Little bit later about your additional question.
Yincognito - thanks for explanation and fixing!
Statistics: Posted by stoyan — Yesterday, 12:37 pm
